8.4.3. Restoration
8.4.3.1. Introduction
The administrator- Backup/Restore section of the GCenter enables data backup and configuration restore.
Note
In the case of a reinstallation or reset of the GCenter, it will be necessary to enter a license in order to access the `Restore`
menu
This procedure describes how to restore a backup.
For |
go to the |
---|---|
Access to the restoration interface |
|
Follow the upgrade and hotfix paths |
|
Restoring a backup to the same GCenter |
|
Restoring a backup |
|
Restoring a backup to another blank GCenter |
Note
Important
The source GCenter has two active interfaces (MGMT0 and VPN0).
Both interfaces must be enabled and configured at the IP level on the target GCenter before performing the restore.
8.4.3.2. Prerequisites
User : member of Administrator group
8.4.3.3. Preliminary operations
Login to GCenter via a browser (see Connecting to the GCenter web interface via a web browser).
8.4.3.4. Procedure to access the restoration interface
In the navigation bar, successively click on:
The
`Admin`
buttonThe
`Backup/Restore`
submenu- The
`Operations`
commandThe`Restore operations`
section is available.
8.4.3.5. Procedure to follow the upgrade and hotfix paths
Astuce
Since the upgrade and hotfix path is not specified in the backup name, it is imperative to set up a tracking of these paths.
To do this, when downloading or exporting the SCP or FTP of the backup:
Create a tree structure indicating the current version of the GCenter (example: 2.5.3.102-XXXX-HFX)
Store the downloaded or exported backup in this folder
Modify the tree structure each time a version is upgraded or a hotfix is applied
Use the backup in the directory of the GCenter version to be restored
8.4.3.5.1. Procedure to restore a backup to the same GCenter
The `Backup operations`
section is available.
- In the
`Backup list`
area (1), click the`Restore`
button (5) of the backup to be restored.After restarting the GCenter, the backup will be restored.
Note
It is essential that the upgrade path be respected, as indicated in the Procedure to follow the upgrade and hotfix paths
8.4.3.5.2. Procedure to restore a backup
From the `Restore operation`
page (10), described above:
Click on the
`Browse`
button (12).Select the backup to restore.
- Click on the
`Restore`
button (13).After restarting the GCenter, the backup will be restored.Note
It is essential that the upgrade path be respected, as indicated in the Procedure to follow the upgrade and hotfix paths
8.4.3.5.3. Procedure to restore a backup to another blank GCenter
In the event of a GCenter replacement, it is mandatory to respect these criteria before restoring the backup:
Reinstall the new GCenter along the same upgrade and hotfix path as the old GCenter.
Name the new GCenter in the same way as the old GCenter (same FQDN).
Configure the network section of the new GCenter, allowing access to the WebUi.
Apply the licence to the new GCenter in order to access all the configurations. Until a license is entered, the WebUI is blocked on the license page.
Once the above steps are completed:
Access the restoration page as described in the previous procedures
Click on the
`Parcourir`
button (12)Select the backup to restore
- Click on the
`Restore`
button (13)After restarting the GCenter, the backup is restored.