6.3. Direct connection to the GCenter configuration menu SSH via the iDRAC interface in serial port forwarding mode

6.3.1. Introduction

This procedure describes the remote connection from a distant computer using:

• The network connection to the iDRAC port of the GCenter

• A connection tool via SSH

This connection is not the normal way to access the GCenter but enables access to the GCenter in the event of problems.

To carry out this procedure, it is necessary:

• That the iDRAC has an accessible IP in order to be able to connect to it

• To know the login name and password to access iDRAC

From the interface, it is possible to:

• View the operating system messages

• Connect to the GCenter via the console

---

6.3.2. Preliminary operations

• Carry out the iDRAC's network configuration.

---

6.3.3. Procedure on the remote PC running Linux

• Open a command prompt.

• Enter the command `ssh identifiant@adresse_ip`.

  For example, `ssh setup@x.x.x.x` where

  • `setup` is the identifier and

  • x.x.x.x is the IP address of the GCenter iDRAC port

• Validate the command.

• Enter the password of the entered login.

• Press `Enter` to display all available commands and a short explanation.

---

6.3.4. Procedure on the remote PC running Windows

• Open an SSH client software, such as Putty.

• Enter the IP address of GCenter's iDRAC interface and confirm.

• Enter the following command `racadm>>console com2`.

• Validate.

  The system now displays the graphical interface of the device.

  Following this action, a new page will open. It will be possible to interact with the GCenter.

---