3. Set hostname and domain name

The network configuration of the equipment is done from the 'Network' tab. :

Once the network configuration has been entered, it is necessary to define a name for the capture probe as well as an associated domain name. This step is mandatory. If the name of the GCap or the domain name is modified then the pairing must be redone. A warning message is displayed if the IPsec link between the two devices has already been created.

↓

You can do it with the following CLI command :

show network-config [hostname|domain]
set network-config domain-name [confirm] [no-reload]
set network-config hostname [confirm] [no-reload]

If all the network information relative to the GCap has been filled in, the system administrator should apply the configuration via 'Save' for this to be taken into account.

→

'Discard' will allow the administrator to exit the network configuration menu without the changes taking effect.