6.2.1.4. clusters
6.2.1.4.1. Introduction
The clusters
command in subgroup show
enables the aggregation of the capture and monitoring interfaces mon
and their configurations to be displayed.
For more information on aggregation, see the paragraph Capture and Monitoring Interfaces monx
between TAP and GCap: Aggregation Capability.
Note
This functionality is necessary if the qualified Test Access Port (TAP) present in the architecture does not provide the interface aggregation functionality.
6.2.1.4.2. Prerequisites
User: setup
Dependencies: activate at least two capture interfaces
6.2.1.4.3. Command
show clusters
6.2.1.4.4. Example for implementing interface aggregation
Refer to the Procedure for Managing Capture Interface Aggregation.
6.2.1.4.5. Example for displaying the interface cluster
Enter the following command.
(gcap-cli) show clusters
Validate.
The system displays the result.
Name State Description Interfaces cluster0 Disabled test mon0, mon1
The system displays the information of the existing aggregations and for each:
name
status
description
interfaces component
Note
If the message No network cluster defined is displayed, check the prerequisites before entering the command.