6.2.7. replay

6.2.7.1. Introduction

A file with the pcap extension is one in which raw network traffic has been captured.

The replay command enables:

  • asking the detection engine to analyse this network traffic to rebuild the packets contained in this flow

  • replaying it with the possibility of modifying the speed compared to that of the initial capture.

Below are the configuration options:

  • List the available pcap files

    • list

  • Choose the name of the pcap file

    • pcap

  • Choose the replay speed

    • speed

  • Choose a loop replay

    • forever

Note

Adding pcap is only possible with supported versions of the GCenter software.

Adding pcap is only possible via the command line with the root account, otherwise contact Gatewatcher support.


6.2.7.2. Prerequisites

  • Users: setup, gviewadm

  • Dependencies:

    • the detection engine is started (UP)

    • The monvirt interface is activated

    • at least one pcap file must be present in the pcap directory


6.2.7.3. Command

replay pcap name.pcap {speed FACTOR} {forever}

replay list

Available commands:

  • forever: means to replay the pcap file until CTRL + C is pressed

  • speed x: x is a number specifying the replay speed of the pcap file (X times the nominal speed)


6.2.7.4. Example of displaying the list of available pcap files

  • Enter the following command.

[Monitoring UP] GCap-lab (gcap-cli) replay list
  • Validate.

Available pcaps are:

name.pcap

6.2.7.5. Example of replaying a pcap file with the capture speed

  • Enter the following command.

(gcap-cli) replay pcap name.pcap speed 4
  • Validate.

Test start: 2022-05-13 14:49:31.287043 ...
Actual: 38024 packets (43981183 bytes) sent in 5.00 seconds
Rated: 8795627.9 Bps, 70.36 Mbps, 7604.27 pps
Actual: 58291 packets (66785902 bytes) sent in 10.00 seconds
Rated: 6678332.4 Bps, 53.42 Mbps, 5828.87 pps
Actual: 83666 packets (95744520 bytes) sent in 15.02 seconds
Rated: 6374049.4 Bps, 50.99 Mbps, 5569.93 pps
Actual: 110051 packets (125880214 bytes) sent in 20.02 seconds
Rated: 6285776.9 Bps, 50.28 Mbps, 5495.35 pps
Actual: 147566 packets (169410025 bytes) sent in 25.02 seconds
Rated: 6769298.3 Bps, 54.15 Mbps, 5896.45 pps
Actual: 169247 packets (193816539 bytes) sent in 30.03 seconds
Rated: 6453918.8 Bps, 51.63 Mbps, 5635.77 pps
Actual: 195575 packets (223882527 bytes) sent in 35.06 seconds
Rated: 6385197.7 Bps, 51.08 Mbps, 5577.85 pps
Actual: 221886 packets (253884171 bytes) sent in 40.09 seconds
Rated: 6331801.8 Bps, 50.65 Mbps, 5533.77 pps
Actual: 260874 packets (298969988 bytes) sent in 45.11 seconds
Rated: 6627011.6 Bps, 53.01 Mbps, 5782.57 pps
Actual: 280646 packets (321206175 bytes) sent in 50.19 seconds
Rated: 6399274.4 Bps, 51.19 Mbps, 5591.20 pps
Test complete: 2022-05-13 14:50:24.974433
Actual: 300745 packets (344377408 bytes) sent in 53.68 seconds
Rated: 6414493.3 Bps, 51.31 Mbps, 5601.78 pps
Flows: 3774 flows, 70.29 fps, 296049 flow packets, 4696 non-flow
Statistics for network device: injectiface
	Successful packets:        300745
	Failed packets:            0
	Truncated packets:         0
	Retried packets (ENOBUFS): 0
	Retried packets (EAGAIN):  0

The system displays the counters approximately every five seconds:

  • throughput in Bps

  • throughput in Mbps

  • throughput in pps (packets)

then the final counters.