6.15. `LPM Mode` command

6.15.1. Introduction

The `LPM Mode` command enables or disables MPL mode.

The current status is indicated. For example, `Disabled` indicates that LPM Mode is disabled.

Note

For more information on the LPM, refer to Military Programming Law (MPL).

---

6.15.2. Prerequisites

• User : setup

---

6.15.3. Preliminary operations

Depending on the situation:

• Either use Direct connection to the GCenter configuration menu via SSH

• Either use Direct connection to the GCenter configuration menu with keyboard and monitor

• Either use Direct connection to the GCenter configuration menu in HTTP via iDRAC (DELL server)

• Either use Direct connection to the GCenter configuration menu SSH via the iDRAC interface in serial port forwarding mode

---

6.15.4. Procedure

The configuration menu is displayed.

• Select the `LPM Mode` line or press the letter L.

• Click on the `OK` button.

  The system displays the following message `Changing LPM mode will need to reboot the appliance. Are you sure?`.

• Click on the `Yes` button.

Important

Please note! The system will reboot when the above operation is performed.

After this reboot, the GCenter will enter the selected mode.

---