6.2.2.16.8. rescan-interfaces
6.2.2.16.8.1. Introduction
The rescan-interfaces
command of the advanced-configuration
subgroup enables:
scanning network interfaces
synchronising the detected network interfaces with the predefined names in the system.
This command is particularly useful if the interfaces are misnamed or out of order. This can happen in some cases with old or unrecognised material.
6.2.2.16.8.2. Prerequisites
User: setup
Dependencies: the detection engine must be switched off
6.2.2.16.8.3. Command
set advanced-configuration rescan-interfaces [no-reboot]
6.2.2.16.8.4. Example of scanning GCap interfaces without rebooting
Note
As the interfaces might be unassigned, access via the SSH connection might not work. Hence, only physical access or access via the management console (iDrac) is possible.
Enter the following command.
(gcap-cli) set advanced-configuration rescan-interfaces no-reboot
Validate.
Operation successful.