9.3.1.5. show gcenter-ip

A - Introduction

The `gcenter-ip` command of the `show` sub-group enables displaying the IP address of the GCenter with which the GCap is paired.

B - Prerequisites

User: setup
Dépendances :
- the detection engine must be switched off
- A GCenter must be paired

C - Command

`show gcenter-ip`

D - Exemple

The command prompt is displayed.

(gcap-cli)

Enter the command
```
show gcenter-ip
```
Validate

The system displays the IP address of the paired GCenter
```
Current GCenter IP:
```
If there is no paired Gcenter then the following message is displayed :
```
Current GCenter IP: None
```