6.2.2.3. compatibility-mode
6.2.2.3.1. Introduction
The compatibility-mode
command of the set
subgroup enables modifying the compatibility mode used to interact with GCenter.
The compatibility mode will affect the available functionality of GCap.
Several compatibility modes are available:
2.5.3.100: GCenter 2.5.3.100 and below
2.5.3.101: GCenter 2.5.3.101
2.5.3.102+: GCenter 2.5.3.102 and above
For a
GCap
|
GCenter
version
|
supported |
Action or
Order to be executed
|
---|---|---|---|
2.5.3.105 |
2.5.3.100 HF7 |
unsupported |
GCenter to migrate to a newer version |
2.5.3.105 |
2.5.3.101 HF3 |
supported |
set compatibility-mode 2.5.3.101 |
2.5.3.105 |
2.5.3.102 |
supported |
set compatibility-mode 2.5.3.102+ |
2.5.3.106 |
2.5.3.100 HF7 |
unsupported |
GCenter to migrate to a newer version |
2.5.3.106 |
2.5.3.101 HF3 |
supported |
set compatibility-mode 2.5.3.101 |
2.5.3.106 |
2.5.3.102 |
supported |
set compatibility-mode 2.5.3.102+ |
2.5.3.107 |
2.5.3.100 HF7 |
unsupported |
GCenter to migrate to a newer version |
2.5.3.107 |
2.5.3.101 HF3 |
supported |
set compatibility-mode 2.5.3.101 |
2.5.3.107 |
2.5.3.102 |
supported |
set compatibility-mode 2.5.3.102+ |
Important
The above table is given as an example. Please refer to the GCap Release Note.
Note
The compatibility mode for GCenter version 2.5.3.100 and below is deprecated.
6.2.2.3.2. Prerequisites
User: setup
Dependencies: the detection engine must be switched off
6.2.2.3.3. Command
set compatibility-mode {2.5.3.100|2.5.3.101|2.5.3.102+}
6.2.2.3.4. Example of configuring compatibility between a GCap version V106 (or V107) with a GCenter 2.5.3.102
Enter the following command.
(gcap-cli) set compatibility-mode 2.5.3.102+
Validate.